This project uses an Arduino to control a 3D LED Cube that cycles through a set of predefined images. Each image is displayed layer by layer using a set of LEDs. The LED Cube is based ojn this one but Pins and wiring are changed. https://www.instructables.com/DIY-3x3x3-LED-Cube-for-Arduino-Nano/
- Arduino board (e.g., Arduino Uno)
- 27 LEDs
- 3 Transistors (to control the LED layers)
- 9 Resistors(150 Ohm)
The Arduino board is connected to the components as follows:
-
LED Pins:
- Pin 2 → LED 1
- Pin 3 → LED 2
- Pin 4 → LED 3
- Pin 5 → LED 4
- Pin 6 → LED 5 (middle LED)
- Pin 7 → LED 6
- Pin 8 → LED 7
- Pin 9 → LED 8
- Pin 10 → LED 9
-
Transistor Pins:
- Pin 18 → Transistor 1 (controls the first layer of LEDs)
- Pin 19 → Transistor 2 (controls the second layer of LEDs)
- Pin 20 → Transistor 3 (controls the third layer of LEDs)
The code is designed to cycle through 26 different images, each represented as a 3D array. Each image is displayed by:
- Selecting a layer using the transistors.
- Setting the state of each LED according to the image data.
- Delaying for a short period to allow the image to be visible.
setup(): Initializes all the pins as output pins.loop(): Cycles through all the images and displays each one for a set duration.displayImage(image): Controls which LEDs are on or off for each layer of the given image.
Each image is defined as a 3D array with dimensions [3][3][3], representing:
- Three layers of the display
- Each layer is a 3x3 grid of LEDs
- Values in the array (0 or 1) determine if an LED is off or on